5 Simple Steps To Put Line On Reel

Published 26 July 2026

The act of spooling fishing line onto a reel may seem like a simple task, but there are a few key steps that you should follow to ensure that your line is properly spooled and ready for use. By following these simple steps, you can avoid problems such as line tangles, twists, and knots, which can all lead to lost fish and frustration on the water.

First, you will need to gather your materials. You will need a reel, a spool of fishing line, and a pair of scissors. If you are using a new reel, it is important to remove the spool from the reel before you begin spooling the line. Once you have gathered your materials, you can begin spooling the line onto the reel. To do this, simply pass the end of the line through the eye of the reel and then wind it around the spool in a clockwise direction. As you wind the line, be sure to keep it tight so that it does not become tangled or twisted.

Once you have spooled the desired amount of line onto the reel, you can secure it by tying a knot in the end of the line and then trimming the excess line. You can now attach the line to your fishing rod and begin fishing. By following these simple steps, you can ensure that your fishing line is properly spooled and ready for use.

Attaching the Line to the Spool

To attach the line to the spool:
1. Locate the arbor hole on the spool.
2. Thread the line through the arbor hole from the inside of the spool to the outside.
3. Wrap the line around the spool several times.

4. Secure the Line to the Spool

To put line on a reel, you will need a reel, fishing line, and scissors. First, open the bail on the reel and thread the line through the guides. Next, tie the line to the spool of the reel using a simple knot, such as a clinch knot. Finally, close the bail and start winding the line onto the reel. As you wind the line, make sure to keep it tight and even. When the reel is full, cut the line and tie it off to the bail.

People Also Ask

How do you put line on a spinning reel?

Follow the steps outlined in the "How To Put Line On Reel" section above.

How do you put line on a baitcasting reel?

To put line on a baitcasting reel, you will need to use a line spooler. First, attach the line spooler to the reel and thread the line through the guides. Next, tie the line to the spool of the reel using a simple knot, such as a clinch knot. Finally, start winding the line onto the reel using the line spooler. As you wind the line, make sure to keep it tight and even. When the reel is full, cut the line and tie it off to the bail.

How much line do I need to put on my reel?

The amount of line you need to put on your reel will depend on the size of the reel and the type of fishing you will be doing. As a general rule of thumb, you should fill the reel to within 1/8 inch of the lip.